Changes to Step #26

Edit by Dave Ogles —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Wiring warnings - MK3(S)
-[* 9] The next steps will not go in all details of the wiring. If you have any doubt or needs more details on how to proceed you can check the original Prusa assembly guides:
- [* 2] [https://help.prusa3d.com/en/guide/8-electronics-assembly-b3-r2-design_73648|MK3 (B3/R2 design)], early version of the electronic cover.
- [* 2] [https://help.prusa3d.com/en/guide/8-electronics-assembly-b7-r3-design_75136|MK3 (B7/R3 design)], the electronic cover has a removable part for the RPi Zero W
+[* 9] The next steps will not cover every detail of the wiring, only those specific to the Bear frame upgrade. If you are unsure of how to proceed with the wiring, not covered by this guide, please consult the original Prusa assembly guides:
+ [* 2] [https://help.prusa3d.com/en/guide/8-electronics-assembly-b3-r2-design_73648|MK3 (B3/R2 design)], early version of the electronics cover.
+ [* 2] [https://help.prusa3d.com/en/guide/8-electronics-assembly-b7-r3-design_75136|MK3 (B7/R3 design)], the electronics cover has a removable part for the RPi Zero W
[* 2] [https://help.prusa3d.com/en/guide/8-electronics-assembly_34416|MK3S]
-[* 9] Be extremely careful and take your time with the wiring. It could be a risk of damaging the printer or worse.
+[* 9] Be extremely careful and take your time with the wiring. Incorrect wiring may pose a risk of damaging the printer, or worse.