Changes to Step #29
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] PSU wiring - MK3(S) |
|---|---|
| [* 11] Direct links to the original Prusa electronic assembly guides: [https://help.prusa3d.com/en/guide/8-electronics-assembly-b3-r2-design_73648|MK3 (B3/R2 design)], [https://help.prusa3d.com/en/guide/8-electronics-assembly-b7-r3-design_75136|MK3 (B7/R3 design)], [https://help.prusa3d.com/en/guide/8-electronics-assembly_34416|MK3S]. | |
| [* 5] Using a Philips screwdriver, connect the 1st pair of wires from the PSU: | |
| [* 2] Positive red wire goes on the red circle | |
| [* 1] Negative black wire goes on the black circle | |
| [* 5] Tighten the screws ***firmly***. | |
| [* 9] Double check you have connected the wires in the correct order and orientation. |