Changes to Step #31
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [* 11] Direct links to the original Prusa assembly guides: [https://help.prusa3d.com/en/guide/8-electronics-assembly-b3-r2-design_73648|MK3 (B3/R2 design)], [https://help.prusa3d.com/en/guide/8-electronics-assembly-b7-r3-design_75136|MK3 (B7/R3 design)], [https://help.prusa3d.com/en/guide/8-electronics-assembly_34416|MK3S]. |
|---|---|
| + | [* 8] Attach the heated bed textile sleeve (or spiral wrap) to the heated bed clamps. |
| + | [* 7] Using a Philips screwdriver, connect the heated bed wires: |
| + | [* 2] Positive red wire goes on the red circle |
| + | [* 1] Negative black wire goes on the black circle |
| + | [* 7] Tighten the screws ***firmly***. |
| + | [* 4] Plug the heated bed thermistor. |
| + | [* 9] Double check you have connected the wires in the correct order and orientation. |
Image 1
No previous image
Added