Changes to Step #31
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| - | [* 11] Direct links to the original Prusa assembly guides: [https://help.prusa3d.com/en/guide/8-electronics-assembly-b3-r2-design_73648|MK3 (B3/R2 design)], [https://help.prusa3d.com/en/guide/8-electronics-assembly-b7-r3-design_75136|MK3 (B7/R3 design)], [https://help.prusa3d.com/en/guide/8-electronics-assembly_34416|MK3S]. |
|---|---|
| + | [* 11] Direct links to the original Prusa electronic assembly guides: [https://help.prusa3d.com/en/guide/8-electronics-assembly-b3-r2-design_73648|MK3 (B3/R2 design)], [https://help.prusa3d.com/en/guide/8-electronics-assembly-b7-r3-design_75136|MK3 (B7/R3 design)], [https://help.prusa3d.com/en/guide/8-electronics-assembly_34416|MK3S]. |
| [* 8] Place the heated bed textile sleeve (or spiral wrap) to the heated right of the electronic cover. Secure it with the printed part and 2x M3x10 screws. | |
| [* 10] This is image shows the design of the MK3 B7/R3 or MK3S electronic cover. The MK3 B3/R2 design is slightly different. | |
| [* 7] Using a Philips screwdriver, connect the heated bed wires: | |
| [* 2] Positive red wire goes on the red circle | |
| [* 1] Negative black wire goes on the black circle | |
| [* 7] Tighten the screws ***firmly***. | |
| [* 9] Double check you have connected the wires in the correct order and orientation. |