Changes to Step #31

Edit by Dave Ogles —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Heated bed wiring - MK3(S)
-[* 11] Direct links to the original Prusa electronic assembly guides: [https://help.prusa3d.com/en/guide/8-electronics-assembly-b3-r2-design_73648|MK3 (B3/R2 design)], [https://help.prusa3d.com/en/guide/8-electronics-assembly-b7-r3-design_75136|MK3 (B7/R3 design)], [https://help.prusa3d.com/en/guide/8-electronics-assembly_34416|MK3S].
-[* 8] Place the heated bed textile sleeve (or spiral wrap) to the heated right of the electronic cover. Secure it with the printed part and 2x M3x10 screws.
- [* 10] This is image shows the design of the MK3 B7/R3 or MK3S electronic cover. The MK3 B3/R2 design is slightly different. Refer to the Prusa guide if necessary.
+[* 11] Direct links to the original Prusa electronics assembly guides: [https://help.prusa3d.com/en/guide/8-electronics-assembly-b3-r2-design_73648|MK3 (B3/R2 design)], [https://help.prusa3d.com/en/guide/8-electronics-assembly-b7-r3-design_75136|MK3 (B7/R3 design)], [https://help.prusa3d.com/en/guide/8-electronics-assembly_34416|MK3S].
+[* 8] Insert the heated bed wiring and textile sleeve (or spiral wrap) through the right of the electronics cover. Secure them with the printed part and 2x M3x10 screws.
+ [* 10] This is image shows the design of the MK3 B7/R3 or MK3S electronics cover. The MK3 B3/R2 design is slightly different. Refer to the Prusa guide if necessary.
[* 7] Using a Philips screwdriver, connect the heated bed wires:
- [* 2] Positive red wire goes on the red circle
- [* 1] Negative black wire goes on the black circle
+ [* 2] Positive, red wire, connects to the screw terminal indicated by the red circle in the image
+ [* 1] Negative, black wire, connects to the screw terminal indicated by the black circle in the image.
[* 7] Tighten the screws ***firmly***.
-[* 9] Double check you have connected the wires in the correct order and orientation.
+[* 9] Double check that you have connected the wires in the correct order and orientation. Note that the wire terminal should go under the washer of the screw terminal.