Changes to Step #32
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| - | [* 11] Direct links to the original Prusa assembly guides: [https://help.prusa3d.com/en/guide/8-electronics-assembly-b3-r2-design_73648|MK3 (B3/R2 design)], [https://help.prusa3d.com/en/guide/8-electronics-assembly-b7-r3-design_75136|MK3 (B7/R3 design)], [https://help.prusa3d.com/en/guide/8-electronics-assembly_34416|MK3S]. |
|---|---|
| + | [* 11] Direct links to the original Prusa electronic assembly guides: [https://help.prusa3d.com/en/guide/8-electronics-assembly-b3-r2-design_73648|MK3 (B3/R2 design)], [https://help.prusa3d.com/en/guide/8-electronics-assembly-b7-r3-design_75136|MK3 (B7/R3 design)], [https://help.prusa3d.com/en/guide/8-electronics-assembly_34416|MK3S]. |
| [* 4] Plug the heated bed connector (has green heat shrink). | |
| [* 8] Plug the Power Panic wires (black and white wires). | |
| [* 5] You can now improve the placements of the cables running along the back of the frame and fully tighten the zip ties. | |
| [* 6] With a zip tie, attach all the cables, including the LCD cables and the left Z motor (from the electronic cover). | |
| [* 9] Make sure there is no tension on the wires and none are pinched. Do not over-tighten the zip ties as you might damage the wires. | |
| [* 9] Check that all connectors are properly plugged in and tight. |