Changes to Step #32

Edit by Dave Ogles —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Heated bed and back cables wiring - MK3(S)
-[* 11] Direct links to the original Prusa electronic assembly guides: [https://help.prusa3d.com/en/guide/8-electronics-assembly-b3-r2-design_73648|MK3 (B3/R2 design)], [https://help.prusa3d.com/en/guide/8-electronics-assembly-b7-r3-design_75136|MK3 (B7/R3 design)], [https://help.prusa3d.com/en/guide/8-electronics-assembly_34416|MK3S].
-[* 1] Plug the following connectors:
+[* 11] Direct links to the original Prusa electronics assembly guides: [https://help.prusa3d.com/en/guide/8-electronics-assembly-b3-r2-design_73648|MK3 (B3/R2 design)], [https://help.prusa3d.com/en/guide/8-electronics-assembly-b7-r3-design_75136|MK3 (B7/R3 design)], [https://help.prusa3d.com/en/guide/8-electronics-assembly_34416|MK3S].
+[* 1] Plug in the following connectors:
[* 4] Heated bed thermistor (has green heat shrink).
[* 8] Power Panic (black and white wires).
-[* 5] You can now improve the placements of the cables running along the back of the frame and fully tighten the zip ties.
-[* 6] With a zip tie, attach all the cables, including the LCD cables and the Z motor on the X motor side.
+[* 5] You can now adjust the placement of the cables running along the back of the frame, if necessary, and carefully tighten the zip ties.
+[* 6] With a zip tie, bundle all of the cables, including the LCD cables and the Z motor on the X motor side, together.
[* 9] Make sure there is no tension on the wires and none are pinched. Do not over-tighten the zip ties as you might damage the wires.
[* 9] Check that all connectors are properly plugged in and tight.