Changes to Step #34
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [* 1] Plug the cables from the extruder: |
|---|---|
| + | [* 5] Extruder heater |
| + | [* 6] Hotend fan |
| + | [* 2] Print fan (has a red heat shrink) |
| + | [* 8] Filament sensor. Both the IR (magnets and ball) and the laser sensors must both be connected to the ***lower row*** and have the ***red wire oriented toward the back*** of the frame. |
| + | [* 7] Extruder motor |
| + | [* 4] Extruder thermistor (has yellow and green heat shrink). |
| + | [* 3] PINDA probe |
Image 1
No previous image
Added
Image 2
No previous image
Added