Changes to Step #34
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Extruder wiring - MK3(S) |
|---|---|
| [* 1] Plug the cables from the extruder: | |
| [* 5] Extruder heater | |
| [* 6] Hotend fan | |
| [* 2] Print fan (has a red heat shrink) | |
| [* 8] Filament sensor. Both the IR (magnets and ball) and the laser sensors must both be connected to the ***lower row*** and have the ***red wire oriented toward the back*** of the frame. | |
| [* 7] Extruder motor | |
| [* 4] Extruder thermistor (has yellow and green heat shrink). | |
| [* 3] PINDA probe |