Changes to Step #34

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Extruder wiring - MK3(S)
[* 1] Plug in all of the cables from the extruder:
[* 5] Extruder heater
[* 6] Hotend fan
[* 2] Print fan (has a red heat shrink)
- [* 8] Filament sensor. Both the IR (magnets and ball, Mk3S) and laser (Mk3) sensors have to be connected to the ***lower row*** and have the ***red wire oriented toward the back*** of the frame.
+ [* 8] Filament sensor. Both the IR (magnets and ball, MK2.5S/MK3S) and laser (MK2.5/MK3) sensors have to be connected to the ***lower row*** and have the ***red wire oriented toward the back*** of the frame.
[* 7] Extruder motor
[* 4] Extruder thermistor (has yellow and green heat shrink).
[* 3] PINDA probe