Changes to Step #37
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [* 1] Prepare the following parts: |
|---|---|
| + | [* 3] ''rambo_hinge_upper'' (might be slightly different depending the Prusa type you are building) |
| + | [* 5] ''rambo_hinge_lower'' (might be slightly different depending the Prusa type you are building) |
| + | [* 7] 2x M5x8 screws |
| + | [* 8] 2x t-nuts |
| + | [* 6] Slide 1x t-nuts from the top. It will fall down to the joining plate but we are going to show you a little trick on the next step. |
Image 1
No previous image
Added
Image 2
No previous image
Added