Changes to Step #37

Edit by Dave Ogles —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Electronic cover door installation
[* 1] Prepare the following parts:
- [* 3] ''rambo_hinge_upper'' (might be slightly different depending the Prusa type you are building)
- [* 5] ''rambo_hinge_lower'' (might be slightly different depending the Prusa type you are building)
+ [* 3] ''rambo_hinge_upper'' (might be slightly different depending on the Prusa model you are building)
+ [* 5] ''rambo_hinge_lower'' (might be slightly different depending on the Prusa model you are building)
[* 7] 2x M5x8 screws
[* 8] 2x t-nuts
-[* 6] Slide 1x t-nuts from the top. It will fall down to the joining plate but we are going to show you a little trick on the next step.
+[* 6] Insert 1x t-nut, into the extrusion, from the top, as shown. It will fall down to the joining plate but we are going to show you a little trick in the next step.