Changes to Step #38

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[* 11] Tech tip: Keep in mind the technique we are using here for later when you will add accessories or do some maintenance on the printer.
[* 10] If you can't achieve this trick, simply rotate the frame to its left side. Be careful with the extruder as it will slide down.
[* 5] Using a hex key (or a zip tie) move the t-nut upper and hold it in place with one hand.
[* 10] Use a hex key 0f 2.5mm size or lower.
[* 7] Take the ''rambo_hinge_lower'' and add an M5x8 screw in the biggest hole. Hold the part and a 3mm hex key with your other hand as shown in the image.
-[* 8] Place the ''rambo_hinge_lower'' on the t-nut and tighten the M3x8 screw. Do not tighten completely yet, we will need to slide it down.
+[* 8] Place the ''rambo_hinge_lower'' on the t-nut and tighten the M5x8 screw. Do not tighten completely yet, we will need to slide it down.
[* 10] You can remove the smaller hex key once the screw is engaged on the t-nut.