Changes to Step #40

Edit by Dave Ogles —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Electronic cover door installation
-[* 5] Secure the electronic cover door with an M3x40 screw (reused from your original Prusa).
-[* 11] Tech tip: when you need to access the electronic, it is helpful to remove completely the door. On the Bear frame it is very easy:
- [* 7] Unscrew partially the ''rambo_hinge_upper'', move it higher up and tighten it back.
- [* 8] Unscrew the M3x40 screw (green circle of 1st image). You can now remove the door completely and have better access to the electronic.
+[* 5] Secure the electronics cover door with an M3x40 screw (reused from your original Prusa).
+[* 11] Tech tip: when you need to access the electronics, it is helpful to remove the door completely. On the Bear frame it is very easy:
+ [* 7] Partially unscrew the ''rambo_hinge_upper'', move it higher up and tighten it in place.
+ [* 8] Unscrew the M3x40 screw (green circle of 1st image). You can now remove the door completely and have better access to the electronics.