Changes to Step #18
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Rear cable routing - MK2(S)/MK2.5(S) |
|---|---|
| + | [* 11] Direct links to the original Prusa electronics assembly guides: [https://help.prusa3d.com/en/guide/8-electronics-assembly_94304|MK2(S)], [https://prusa3d.dozuki.com/Guide/6.+Electronics/573?lang=en|MK2.5], [https://help.prusa3d.com/en/guide/5-electronics_52680|MK2.5S] |
| + | [* 5] Gather together PSU cables with the right Z motor (on the PSU side). Those cables are too short to be rooted to the back on MK2(S)/MK2.5(S). |
| + | [* 7] Create an S with the Y end stop cable to avoid straining this wire. |
| + | [* 8] The Y motor cable is a little too long. To help with the wiring you can create a small loop with the excess length. |
| + | [* 6] Gather the Y motor cable and Y end stop cable and add 4 zip ties to group the cables as shown in the image. Do not tighten the zip ties yet as you may need to readjust the position of some cables. |
| + | [* 9] Make sure no wire is under tension. Do not over-tighten the zip ties or you could damage the wires. |
Image 1
No previous image
Added
Image 2
No previous image
Added