Changes to Step #2
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Extruder attachment |
|---|---|
| [* 7] Clamp the extruder on the top and bottom linear bearings of the X axis | |
| [* 2] Make sure all cables are running on top of the bottom smooth rod (between two X smooth rods) | |
| [* 4] Clamp the top of the ''x_carriage_back'' | |
| [* 5] Secure it with two M3x10 screws in top holes. Don't tighten them right now! | |
| [* 3] Finish securing it with two M3x18 screws in bottom holes. Don't tighten them right now | |
| [* 6] Alternatively tighten the four screws while moving the extruder. Don't over tighten them. |