Changes to Step #2

Edit by Matthew Harrison —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Extruder attachment
[* 7] Clamp the extruder on the top and bottom linear bearings of the X axis
[* 2] Make sure all cables, except hotend cables, are running on top of the bottom smooth rod (between two X smooth rods). The hotend cable should stay under the bottom smooth rod.
[* 4] Clamp the top of the ''x_carriage_back''
[* 5] Secure it with two M3x10 screws in top holes. Don't tighten them right now!
[* 3] Finish securing it with two M3x18 screws in bottom holes. Don't tighten them right now
-[* 6] Alternatively tighten the four screws while moving the extruder. Don't over tighten them.
+[* 6] Gradually tighten each of the four screws while moving the extruder. Don't over tighten them.