Changes to Step #4
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Attach the belt |
|---|---|
| + | [* 3] Slide one end of the 2GT timing belt int right side of the ''x_carriage''. |
| + | [* 9] Verify that the belt is completely pressed into the slot and that it extends to the central portion. |
| + | [* 6] Route the timing belt through the ''x_end_motor'', around the pulley and back out through the ''x_end_motor''. |
| + | [* 7] Route the timing belt through the ''x_carriage''. |
| + | [* 5] Continue to route the timing belt around the idler of the ''x_end_ilder_idler_mount'' and go back in the direction of the ''x_carriage''. |
| + | [* 4] Slide the end of the 2GT timing belt into the x_carriage. If necessary, trim the timing belt. There is a little opening to have belt on top of each others in case they are a bit long. |
| + | [* 9] Verify that the belt is completely pressed into the slot. |
| + | [* 9] Verify that no cable from the extruder are pinched in the belt. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added