Changes to Step #4

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Attach the belt
-[* 3] Slide one end of the 2GT timing belt int right side of the ''x_carriage''.
+[* 3] Slide one end of the 2GT timing belt into right side of the ''x_carriage''.
[* 9] Verify that the belt is completely pressed into the slot and that it extends to the central portion.
[* 6] Route the timing belt through the ''x_end_motor'', around the pulley and back out through the ''x_end_motor''.
[* 7] Route the timing belt through the ''x_carriage''.
[* 5] Continue to route the timing belt around the idler of the ''x_end_ilder_idler_mount'' and go back in the direction of the ''x_carriage''.
[* 4] Slide the end of the 2GT timing belt into the x_carriage. If necessary, trim the timing belt. There is a little opening to have belt on top of each others in case they are a bit long.
[* 9] Verify that the belt is completely pressed into the slot.
[* 9] Verify that no cable from the extruder are pinched in the belt.