Changes to Step #11

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Wiring extruder to Rambo
[* 1] Finish to wrap the spiral up to the Rambo Mini / Einsy.
-[* 1] Follow the original Prusa manual to connect your extruder cables on the Rambo Mini / Einsy :
+[* 1] Follow the original Prusa manual to connect your extruder cables on the Rambo Mini / Einsy:
[* 1] [https://manual.prusa3d.com/Guide/8.+Electronics+assembly+(B3-R2+design)/513?lang=en|MK3 guide]
[* 1] [https://manual.prusa3d.com/Guide/6.+Electronics/573?lang=en|MK2.5 guide]
[* 1] [https://manual.prusa3d.com/Guide/8.+Electronics+assembly/279?lang=en|MK2s guide]