Changes to Step #4

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Duet 3 Mini 5+ Installation
-[* 2] Make sure to use the printed ''***board_washers***'' between the screw heads and the board.
-[* 5] Secure the board in ***''board_cover''*** with 4x ***M3x10mm*** screws. Be careful not to over-tighten the screws as this might damage the board.
+[* 2] Slide the printed 4x ''board_washers'' on each 4x M3x10 screws.
+[* 5] Secure the board in ''board_cover'' with the 4x M3x10mm screws and washers. Be careful not to over-tighten the screws as this might damage the board.