Changes to Step #1

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Preparation I
-[* 5] Insert 3x ***M3 square nuts*** in ***''board_cover''***.
-[* 4] Insert 4x ***M3 hex nuts*** in ''***board_cover***''.
-[* 3] Insert one ***M3 square nut*** on the inside of the case.
-[* 8] Insert one more ***M3 square nut*** in ***''board_cable_clamp_bed''***.
- [* 9] Make sure to fully insert the nuts!
+[* 5] Insert 3x M3 square nuts in ''board_cover''.
+[* 4] Insert 4x M3 hex nuts in ''board_cover''.
+[* 3] Insert one M3 square nut on the inside of the case.
+[* 8] Insert one more M3 square nut in ''board_cable_clamp_bed''.
+[* 9] Make sure to fully insert the nuts!