Changes to this Step
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Pinda adjustment |
|---|---|
| + | [* 6] Place a sheet of paper on your heated bed. Remove any residual filament going out of the nozzle. |
| + | [* 1] Ensure the hotend have cooled down and turn off the printer. |
| + | [* 2] Center your extruder on the X axis. Move it down by rotating simultaneously the Z lead screws. Go down until the nozzle is just touching the paper. |
| + | [* 7] Place the middle section of a zip tie under the Pinda. |
| + | [* 5] Release the M3x10 screw and gently press down the Pinda against the middle section of the zip tie. |
| + | [* 5] Tighten the M3x10 screw. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added