Changes to this Step
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Z calibration preparation |
|---|---|
| + | [* 1] Turn on the printer. |
| + | [* 1] Heat up the nozzle and insert PLA filament. Plain grey without sparkle is the best color for calibration. |
| + | [* 5] Run Z calibration. |
| + | [* 1] Because the extrusion multiplier and filament diameter are not calibrated yet, it will only give a first approximation of the first layer height. |
| + | [* 9] If you have setup a different estep value in the past I recommend to reset it to its default. |
Image 1
No previous image
Added