Changes to Step #7
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| - | [title] Calculate new extrusion multiplier |
|---|---|
| + | [title] Calculate the new extrusion multiplier |
| [* 1] Calculate your new extrusion multiplier using the formula on the 1st image. Here is an example: | |
| [* 1] Your original extrusion multiplier = 1.00 and your average perimeter thickness = 0.47mm. | |
| [* 1] Your are using a 0.4mm nozzle, so your target/expected extrusion width is 0.45mm. | |
| [* 1] Your new extrusion multiplier = (1.00 · 0.45)/0.47 = 0.957 | |
| [* 8] Enter the new extrusion multiplier value in the filament settings page of PrusaSlicer. | |
| - | [* 11] ***Tip:*** The extrusion multiplier is generally constant for a whole spool (if you do not change temperature) but the filament diameter will change. Therefore, before slicing a part, measure the filament diameter you are going to use and enter it into PrusaSlicer. |