Changes to Step #4
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Slice and print |
|---|---|
| + | [* 3] Start Slic3r PE and load the calibration cube. On the main page, select the following parameters: |
| + | [* 3] Print settings: 0.20mm Normal |
| + | [* 3] Filament: Prusa PLA |
| + | [* 7] Report filament diameter to the filament settings. |
| + | [* 8] Reset "Extrusion multiplier" to 1mm. |
| + | [* 5] MK3(S) only: comment the M221 command line in Printer Settings -> Custom G-code -> Start G-code |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added