Changes to Step #4

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Slice and print
[* 3] Start Slic3r PE and load the calibration cube. On the main page, select the following parameters:
[* 3] Print settings: 0.20mm Normal
[* 3] Filament: Prusa PLA
[* 7] Report filament diameter to the filament settings.
-[* 8] Reset "Extrusion multiplier" to 1mm.
-[* 5] MK3(S) only: comment the M221 command line in Printer Settings -> Custom G-code -> Start G-code
+[* 8] Reset "Extrusion multiplier" to 0.95mm.
+[* 5] MK3(S) only: disable by commenting the M221 command line in Printer Settings -> Custom G-code -> Start G-code