Changes to Step #4
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| - | [title] |
|---|---|
| + | [title] Extrusion multiplier and filament diameter settings |
| [* 3] Start Slic3r PE and load the calibration cube. On the main page, select the following parameters: | |
| [* 3] Print settings: 0.20mm Normal | |
| [* 3] Filament: Prusa PLA | |
| [* 7] Report filament diameter to the filament settings. | |
| [* 8] Reset "Extrusion multiplier" to 0.95mm. | |
| [* 5] MK3(S) only: disable by commenting the M221 command line in Printer Settings -> Custom G-code -> Start G-code |