Changes to Step #4

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Extrusion multiplier and filament diameter settings
-[* 3] Start Slic3r PE and load the calibration cube. On the main page, select the following parameters:
+[* 3] Start Slic3r PE and load the calibration model. On the main page, select the following parameters:
[* 3] Print settings: 0.20mm Normal
[* 3] Filament: Prusa PLA
[* 7] Report filament diameter to the filament settings.
[* 8] Reset "Extrusion multiplier" to 0.95mm.
[* 5] ***MK3(S) only:*** disable by commenting the M221 command line in Printer Settings -> Custom G-code -> Start G-code