Changes to Step #4
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| - | [title] |
|---|---|
| + | [title] Filament settings |
| [* 5] Start PrusaSlicer and load the calibration model. On the main page, select the following parameters: | |
| [* 5] Print settings: 0.20mm QUALITY | |
| [* 5] Filament: choose the filament profile corresponding to the filament you want to calibrate. | |
| [* 7] Enter your measured filament diameter into the corresponding input under filament settings. | |
| [* 8] Set your extrusion multiplier to 1.00 |