Changes to Step #8
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| [title] Verification | |
| [* 1] Slice and print the calibration model again with the new extrusion multiplier value. | |
| [* 1] Verify the wall thickness with your micrometer. Repeat the previous steps if refinement is needed. | |
| + | [* 11] ***Tip:*** The extrusion multiplier is generally constant for a whole spool (if you do not change temperature) but the filament diameter will change. Therefore, before slicing a part, measure the filament diameter you are going to use and enter it into PrusaSlicer. |