Changes to Step #8

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Verification
-[* 1] Print the calibration model again with these new settings.
-[* 1] Verify the wall thickness with your micrometer. Repeat the previous steps one or two more times if refinement is needed.
+[* 1] Slice and print the calibration model again with the new extrusion multiplier value.
+[* 1] Verify the wall thickness with your micrometer. Repeat the previous steps if refinement is needed.