1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
Introduction
Details
Guide Steps
Review
Quiz
Ensure the hotend has cooled down and turn off the printer.
Place a sheet of paper on your heated bed. Remove any residual filament coming out of the nozzle.
Center your extruder on the X axis. Move it down by rotating both the Z lead screws at the same time. Move the extruder down until the nozzle is just touching the paper.
Stop when the nozzle is just touching the paper.
Place the middle section of a zip tie under the Pinda.
Loosen the M3x10 screw and gently move the PINDA down until it is touching the zip tie.
Tighten the M3x10 screw to secure the PINDA in place.
« Introduction
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.