1. Unload the filament and allow the hot end to cool. Turn off the printer and remove the power plug.

2. Protect the printing surface and use a tray to catch small components that might fall during the disassembly.

3. Remove the M3x40 screw securing the Rambo/Einsy cover and disconnect all the plugs, from the board that make up the extruder cable bundle.

4. Cut the zip ties and remove the screws clamping the extruder cable to the Rambo/EINSY box and remove the 3mm nylon filament. Completely unwind the spiral/fabric wrap from the cables.

5. Cut the zip ties securing the extruder cables on the cable guide and remove the cable wrapping. Untangle the wires.

6. Unscrew and remove the cable guide.

Be careful to not cut the cables while cutting the zip ties.