Turn the printer off and and then on.
Run the "Selftest" in calibration settings.
If errors occur during selftest, please fix them before going further.
In Settings -> Temperature -> Fan speed set the value at 130 if you print lots of PETG and 255 if you print lots of PLA. For other materials select a value suitable for your most used filament.
Run PID calibration in calibration settings.
Choose a temperature that matches your most used printing temperature.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.