Bear 2.1 Frame Assembly
View
Options
History
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
Introduction
Details
Guide Steps
Review
Quiz
These images show the Rambo Einsy board and cover but the screws on other boards are in the same positions.
Remove the Rambo cover door and unscrew the M3 screws holding the cover.
Remove the two M3 screws on the left of the Rambo board.
Do not unscrew the two screws on the right.
Remove the two hex nuts, on the right as viewed from the back of the Rambo cover. You can insert an M3 screw into them and pull.
« Previous
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.