Bear 2.1 Frame Assembly
View
Options
History
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
Introduction
Details
Guide Steps
Review
Quiz
Take your time with this step. It is the last step for squaring the Y axis :).
Place the frame flat on the table, ensuring that the reference corner is at the back left position.
Carefully insert the 290mm extrusion between the two Y extrusions, as shown in the 1st image.
Be careful that you do not scratch or permanently mark the extrusions whilst doing this.
Apply pressure, in the direction of the arrows, as shown in the image, and fully tighten the M5 screws.
« Previous
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.