Editing Step 10 —
Assemble X carriage

Step Type:

Drag to rearrange

Secure the Pinda on the pinda_mount with an M3x10 screw. The PINDA should be out in the bottom by approx. 10mm

Route the stepper motor, nozzle fan and PINDA as shown in the second image. Make sure to not pinch any wires

Attach the x_carriage on the body_back with two M3x18 screws

And one M3x10

Double check you didn't pinch any wires. You should be able to slide them a little if you push/pull on them.

Your contributions are licensed under the open source Creative Commons license.