Bear 2.1 Frame Assembly
View
Options
History
1
2
3
4
5
6
7
8
9
10
11
Introduction
Details
Guide Steps
Review
Quiz
Be careful and take your time with this step to not damage the Z lead screw nuts and bearings.
Place the X axis on top of the Z lead screws. Carefully rotate, by hand, both Z lead screws to engage with the nuts and move down the X axis.
Never apply force on the lead screw nuts or you might damage them.
Rotate both lead screws, simultaneously, keeping the X axis level as it moves down the Z axis.
Continue to rotate both Z lead screws until you can align the top X smooth rod with the bottom of top Z axis extrusion.
Check that the X axis is parallel and rotate one or other of the lead screws until it is.
Very gently, insert the two Z smooth rods (320mm long) into the bearings and down to the Z motors. The smooth rods must be fully inserted. They must touch the Z motor body itself (you can hear a "metallic click" when you reach the motor).
Verify the Z smooth rods are fully inserted into the Z motor mount and actually touch the Z motors. This is very important as it might affect the alignment of your X axis later.
« Previous
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.