Place a sheet of paper on your heated bed. Remove any residual filament coming out of the nozzle.
Ensure the hotend has cooled down and turn off the printer.
Center your extruder on the X axis. Move it down by simultaneously rotating the Z lead screws. Go down until the nozzle is just touching the paper.
Place the middle section of a zip tie under the Pinda.
Release the M3x10 screw and gently press down the Pinda against the middle section of the zip tie.
Tighten the M3x10 screw.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.