Extruder And X Axis 0.6.0-a Assembly
View
Options
Preview new Authoring Experience
History
1
2
3
4
5
6
7
8
9
10
11
12
Introduction
Details
Guide Steps
Review
Quiz
Insert four M3 square nuts on the x_carriage_back
Tweezers are handy to insert those square nuts.
If you have trouble inserting the top left square nut, slowly unscrew the M3x40mm screw just above. Be careful not to lose the two nylon washers and don't forget to screw it back in place!
« Introduction
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.