Route the timing belt through the x_carriage.
Continue to route the timing belt around the idler of the x_end_ilder_idler_mount and go back in the direction of the x_carriage.
To finish routing the timing belt, attach few belt teeth in the x_carriage.
The belt should have almost no tension, it will be adjusted later.
Estimate the length and cut the belt. Finish to insert it in the x_carriage
Verify that the belt is completely pressed into the slot and that it extends to the central portion.
Verify that no cable is pinched by the belt.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.