Gather the extruder cable bundle, the 3mm nylon stiffener and the hotend cables together.
Continue to wrap the textile sleeve around all of the cables right up to the end.
Trim the two bottom zip ties.
Add 3 zip ties to secure the textile sleeve to the top of the cable_guide_back. Ensure that the ties are arranged as shown.
Add one more zip tie after the junction with hotend and nylon cables.
Trim the zip ties.
It is important that the heads of the zip ties are arranged, so that they are at the top or bottom of the cable bundles, otherwise they may interfere with the full travel of the extruder along the x-axis.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.