Repeat the 3 previous steps on the x_end_motor

MK2(S) or MK2.5(S) only: Use two M2x12 screws to attach the x-endstop switch. Ensure the correct orientation of the switch. The microswitch should be oriented so that it is closest to the v-notch in the printed part.

MK2(S) or MK2.5(S) only: While tightening the screws, apply gentle pressure in the direction shown.

MK2(S) or MK2.5(S) only: Do not over-tighten the M2x12 screws!

MK2(S) or MK2.5(S) only: Double check the orientation of the endstop.