Installed Apps
BearExxa 1.0 Assembly
View
Options
History
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Introduction
Details
Guide Steps
Review
Quiz
Check the holes for the smooth rods in the x_end_motor part and ensure that they are clean and free from obstructions.
Slide the two 370mm smooth rods in the x_end_motor.
Ensure that the smooth rods are fully inserted. You can check in the little windows on top and bottom.
If it is too hard to insert the smooth rods you can use a quality metal drill of 8mm and hand drill the first centimeter. Warning: don't drill the hole up to the end, only the first centimeter.
« Previous
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.