Hotend wires are not visible in these images. Use the heatblock to orientate the hotend correctly.
Push down the PTFE tube while raising up the collet.
Insert the hotend_collet_clip. This locks the PFTE tube in place.
Insert the hot end into the extruder_body so that the heater and thermistor wires are properly oriented.
Note the position of the heater and thermistor wires.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.