Place a square nut in the extruder_body for the pinda_mount.

Slide an M3x10 screw in the pinda_mount and engage the square nut, but do not tighten.

Insert the Pinda in the mount so that the sensor end is 12mm below the bottom of the pinda_mount. Tighten the screw just enough to keep the Pinda from falling out. The optimum Pinda position will be adjusted later.

Route the Pinda wires

Route the print fan wires

Secure the cables with a zip tie. Be sure to leave some slack since the Pinda position will need to be adjusted later.

This is an example of how the Pinda and print fan cables should be wired.