Carefully route the motor wires as shown in the figure.
Make sure the wires sit correctly in the channel.
This surface will be touching the extruder_body. Wires are going out from this side.
Carefully route the hotend fan wires in the x_carriage.
Attach the hotend fan with four M3x14 rounded head screws.
Check that no wires are pinched.
Check hotend fan orientation.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.