Editing Step 14 —
Extruder idler assembly

Step Type:

Drag to rearrange

Slide a M3 washer on a M3x40 screw.

Insert the screw into the top, left hole of the x_carriage, until it protrudes just enough for you to place a M3 washer on it.

Carefully place a M3 washer on the end of the screw.

Carefully slide the extruder_idler into the opening, taking care not to displace the M3 washer and insert the screw to act as the hinge for the idler door.

Gently tighten the screw into the extruder motor, the extruder_idler must rotate freely.

Your contributions are licensed under the open source Creative Commons license.