Place a square nut in the extruder_body for the pinda_mount.

Slide a M3x10 screw into the pinda_mount and engage the square nut, but do not tighten yet.

Insert the PINDA into the mount so that the sensor end is approximately 12mm below the bottom of the pinda_mount. Tighten the screw just enough to keep the PINDA from falling out. The optimum PINDA position will be adjusted later.

Route the PINDA wires as indicated

Route the print fan wires as indicated

Secure the wires with a zip tie. Be sure to leave some slack since the PINDA position will need to be adjusted later.

This is the preferred example of how the PINDA and print fan cables should be wired.